Fence Calculator

Ajustez les valeurs, puis sélectionnez Calculer pour voir le résultat.
ft
ft
Résultat
Saisissez vos valeurs, puis sélectionnez Calculer.

The detailed guide below is currently available in English.

How the post count works

A straight run divides its length by the post spacing, rounds up to whole intervals, then adds one post to close the far end — a 100-foot fence on 8-foot spacing needs thirteen intervals and therefore fourteen posts. Every gate adds one more post because a gate needs a hinge side and a latch side. Corners and direction changes each want a braced post too, so L-shaped runs cost more posts than the straight-line math suggests.

Two rails or three?

Two rails carry most privacy and wood picket fences comfortably on 6–8 foot spacing. Three rails earn their keep on taller fences, wide post spacing, stock panels, or anywhere animals (or large dogs) lean on the fence — the middle rail stops boards from bowing between posts. Rail length multiplies the full run, so three rails on a 100-foot fence means 300 linear feet of material to buy.

Repères pour la France

Repères locaux pour la France, utiles dans les calculs du quotidien :

  • TVA: 20 % en taux normal (5,5 % alimentaire, 10 % restauration) ; les prix sont TTC par loi.
  • Monnaie & paiements: Euro (€) ; paiement sans contact et carte bancaire très répandus, virement SEPA instantané en développement.
  • Unités & nombres: Système métrique ; virgule décimale et espace pour les milliers : 1 234,56 €.
  • Santé: Carte Vitale ; l'Assurance Maladie rembourse en base ≈ 70 % des soins, le reste par mutuelle.
  • Pourboire: Service compris : aucun pourboire obligatoire ; arrondir suffit.

Mis à jour : octobre 2026 · valeurs 2025, sources officielles ci-dessus.

Questions fréquentes

What post spacing should I use?

Six to eight feet is standard for wood and vinyl; check your fence panel width first, because panels that span post to post lock you into their length. Windy, exposed sites often tighten spacing to six feet.

Do gates change the rail length?

A gate replaces a span of rail rather than extending the fence, so this calculator keeps rail length at the full run — you will buy slightly more rail than strictly needed, which covers the frame lumber gates consume anyway.

Are corner and end posts included?

The two ends of the run are included by the plus-one rule. Each corner or turn adds one more post that the straight-line count cannot see — add them mentally for L- or U-shaped layouts.

Calculatrices associées